Advertisement
About This Guide
This guide gives step by step instructions for
setting up D-Link DBG-2000. Please note that the
model you have purchased may appear slightly
different from those shown in the illustrations.
Unpacking the Product
Open the shipping carton and carefully unpack its
contents. Please consult the packing list located
in following information to make sure all items are
present and undamaged. If any item is missing
or damaged, please contact your local D-Link
reseller for replacement.
- One (1) DBG-2000 One (1) 12V/2A Power
Adapter
- One (1) Console Cable (RJ45-to-DB9 Cable)
- One (1) Ethernet (CAT5 UTP/Straight Through)
Cable
- Four (4) Rubber foot
Product Overview
This chapter provides detailed descriptions of the
DBG-2000 device and its components.
Front Panel
A
B
Figure 1. DBG-2000 Front Panel
Item Feature
Description
A
LED
Power LED: Indicates the device is
powered on.
(Top to bottom)
B
Ethernet ports
Connect Ethernet devices, such as
computers, switches and hubs.
(1-4)
C
Gigabit WAN
Two auto MDI/MDIX WAN ports
are the connection for the Ethernet
port (2)
cable to the cable or DSL modem.
D
Console Port (1)
Used to access Command Line
Interface (CLI) via RJ45-to-DB9
console Cable.
2 D-Link Nuclias Cloud Router
E
Device Status LEDs and Ethernet Port LEDs
The device LEDs show information about current
device status. When the device power up, the
POWER/STATUS LED will show solid orange
during power on process. Startup takes one minute
approximately to complete, the LED will change
to solid green. If you want to turn the device off
and on again, we recommend you wait a few
seconds between shutting it down and powering it
back. The Ethernet LEDs show the status of each
Ethernet port. Table 2 lists the name, color, status
and description of each device LED.
LED
Indicative
Power
Cloud
LAN
RJ45
Phone
Jack
C
D
E
WAN
RJ45
Phone
Jack
USB Port (1)
It can support various USB 2.0, 3.0
devices below:
1.Flash Disk or Hard Disk for
network sharing.
2.Printer (It will be supported by
future firmware upgrade)
Table 1: DBG-2000 Front Panel Descriptions
Link
Speed
Figure 2. Ethernet RJ-45 Port LEDs
Color
Status
Orange/
Solid Orange
Green
Solid Green
Light Off
Green/
Solid Orange
Orange/
Solid Green
Red
Solid Red
Blinking
Orange
Green/
Right Side
Amber
Solid Amber
Blinking
Amber
Light Off
Left Side
Solid Green
Blinking Green
Light off
Blue/
Right Side
Green/
Solid Green
Amber
Solid Amber
Blinking
Green/Amber
Light Off
Left Side
Solid Blue
Blinking Blue
Light Off
Table 2: Device Status LED Descriptions
TX/RX
Status
Description
Device during power-on
process
Completion of power on
The device is power-off
Device is connecting to Cloud
Device is in Cloud mode
Device is not in Cloud mode
Device is upgrading firmware
or resetting factory default
10/100Mbps Link Present
There is activity on this port
No link
1000Mbps Link Present
There is activity on this port
No Link
1000Mbps Link Present
10/100Mbps Link Present
There is activity on this port
No link
2.5Gbps Line Present
There is activity on this port
No link
Advertisement
