Figure 27: Port 1 Setup (Sentences) Screen - NorthStar 961 Install Manual

961/962 INSTALLATION MANUAL Revision A
sentences on or off. In general, you may want to turn on only those
sentences used by the particular equipment to which you're interfacing.
To modify the selection of output sentences, at the PORT 1, PORT 2, or
PORT 3 SETUP (sentences) screen, press the
To set the output sentences to the factory default settings:
1. Press the
2. Press the
SETUP screen.
To select only a few specific sentences:
1. Press the
each desired sentence, pressing the
sentence will be outlined in flashing green).
2. When done selecting all sentences, press the
3. Press the
3 SETUP screen.
About the NMEA TLL sentence
The 961/962 also supports the NMEA TLL sentence, sometimes referred
to as the "rattle" sentence. This sentence allows the 961/962 to
communicate its position to an interfaced radar device, which tracks a
user-defined target. In turn, the interfaced radar device communicates to
the 961/962 the target's position in lat/lon coordinates so that you can
see the target symbol displayed right on the 961/962's CHART screen. To
have the TLL sentence input properly, you must set to "output" the port
to which you're connecting.

Figure 27: Port 1 setup (sentences) screen

key, then press the
key to go back to the PORT 1, PORT 2, or PORT 3
key, then press the
key to go back to the PORT 1, PORT 2, OR PORT
SECTION THREE - Interfacing
key.
key.
to select
key for each one (the
key.
Page 49