NorthStar 961 Install Manual page 72

SECTION FOUR - Service/Maintenance
Viewing GPS
status
Page 62
the baud rate to any of the four standard rates: 25 bps, 50 bps, 100 bps, or
200 bps.
To choose manual mode:
1. At the
highlight the
2. Press the
key.
3. Press the
4. Use the
5. When done, press the
option unchanged).
Manually setting baud rate
Northstar strongly recommends leaving the beacon baud rate setting at
. To manually set the baud rate for the selected differential
frequency (the BEACON FREQ field must be set to manual):
1. At the
highlight the
2. Press the
bps.
3. When done, press the
option unchanged).
The 961/962's
satellites, including their signal strength and your expected accuracy, as
well as the frequency, baud rate, and status of DGPS transmitters (961XD/
962XD only). To display this information, press the
reach the
screen, press the
field, then press the
to highlight the MAN field, then press the
key.
to enter the desired frequency.
key (or press
screen, press the
field, then press the
left or right to highlight
key (or press
screen shows you all available
screen, then press the
961/962 INSTALLATION MANUAL Revision A
to
key.
to leave the
to
key.
, , , or
to leave the
key until you
key.