Setting the aux
port's output
format
Changing the aux
port's baud rate
Setting PPNM
961/962 INSTALLATION MANUAL Revision A
2. Press the
then press the
unchanged).
Table 8 outlines the aux port's setup parameters, which are explained in
detail below.
Table 8: Aux port setup parameters
Parameter
Options
Output format
Choose
P3 (
NMEA 0183 baud rate
Choose
SC-104 OUT outputs differential corrections from the 961/962XD's
•
internal differential receiver to an external device that accepts the
standard SC-104 data stream. When using the SC-104 OUT setting,
be sure that the BAUD setting also matches the baud rate
requirements of the receiving device.
SC-104 IN
•
P1, P2, and P3
•
The DIAGNOSTICS option is for factory diagnosis of 961/962
•
operating parameters. Do not turn this function on.
OFF is used when the aux port's input or output functions aren't
•
needed.
The aux port's baud rate must match the external device's baud rate; for
the correct baud rate setting, see the external device's instructions, then
follow the steps for changing the aux port setting.
To access the pulses per nautical mile (PPNM) options:
key to access the SERVICE MENU screen.
1. Press the
2. Press the
key. The 961/962 displays the PPNM OUTPUT SETUP
3. Press the
screen, with configurable options for number of pulses per nautical
mile, pulse-time minimum, and pulse-separation minimum. The
PPNM default settings are 200 ppnm, 100 milliseconds, and 200
milliseconds.
left or right to highlight the desired setting,
key (or press
104-O (
)
104-I (
out
,
in),
)
DIAG (
port 3
, or
diagnostic
300
1200
2400
4800
,
,
,
key to display the PORT SETUP screen.
SECTION THREE - Interfacing
to leave the option
P1 (
)
P2 (
)
port 1
,
port 2
)
9600
19200
,
, or
Page 53
,