Figure 24: Port 1 Output Setup Screen; Table 6: Port Setup Options - NorthStar 961 Install Manual

Field Name
Format
Talker ID
Send Every
0183 Prec
0183 Wpts
0183 Sum
0183 Baud
961/962 INSTALLATION MANUAL Revision A
For any special requirements, check the installation instructions of the
equipment to which you're interfacing. The Northstar factory settings will
be adequate for most peripheral equipment, but the options described in
Table 6, "Port setup options," on page 45, are available if needed.

Table 6: Port setup options

Parameter
OUTPUT FORMAT
(see below)
NMEA 0183 Talker ID
(see page 50)
OUTPUT RATE
(see page 51)
NMEA 0183 lat/lon precision
(see page 50)
NMEA 0183 waypoint ID as
(see page 51)
NMEA 0183 checksums
(see page 51)
NMEA 0183 baud rate
SECTION THREE - Interfacing

Figure 24: Port 1 output setup screen

Options
choose OFF, 0180, 0183, 0183-R, CDX, or
PORT 3 OUTPUT SETUP
490 (only on the
screen if the echo sounder has been
installed)
choose GP or II to make the unit look like a
GPS receiver or an "integrated instrument"
(II)
choose 1 to 199 seconds
choose hundredths of minutes, thousandths
of minutes, or ten-thousandths of minutes
choose NAMES or NUMBERS for the
identifier of waypoints sent to the external
device
choose ON or OFF for compatibility with
some older devices
The baud rate is fixed at 4800
Page 45