Figure 11: Correct An205-P (Combo Antenna) Splitter Wiring - NorthStar 961 Install Manual

SECTION TWO - Installation
Page 22

Figure 11: Correct AN205-P (combo antenna) splitter wiring

After you've mounted the antenna and cut the cable to length—not less
than 20 feet—install the supplied TNC connector at the 961/962 end. See
Figure 12, Figure 13, and Figure 14 below. A satisfactory crimp for this
connector can be made with a common high-quality crimping tool
designed for use with TNC connectors.
Be sure that you properly install the TNC connector: Most
system failures—whether continuous or intermittent—can be
traced to poor connector installation.
Mounting the AN205-P antenna
Tools needed:
•
flat-bladed screwdriver
• knife blade
• Amphenol crimp tools
1. Strip the cable jacket to the dimensions (shown in inches) in "Figure
12: Stripping the coax cable jacket" below. Don't nick the center
conductor.
AS105/AS110
NOTE:
961/962 INSTALLATION MANUAL Revision A