Section Four - Service/Maintenance; Service Functions; Figure 30: Product Information Screen - NorthStar 961 Install Manual

SECTION FOUR - Service/Maintenance

Service functions

Viewing product
information
961/962 INSTALLATION MANUAL Revision A
T
his chapter explains the options at the
viewing product information, configuring the receivers, viewing GPS
status, and saving and restoring 961/962 databases and system logs. The
port setup option is introduced here, but is described in detail in
"SECTION THREE - Interfacing" beginning on page 43.
The 961/962's
information about the 961/962's control head, processor, GPS receiver,
and DGPS receiver (if installed). To display this information, press the
key to access the
key:
Viewing head 1 serial number and software revision
The complete 961/962 system comprises two or three serial numbers, one
for each control head and one for the processor. The serial number of the
control head is affixed to the back of the unit. You can view this serial
number at the
the
displayed in the other two boxes.
Viewing head 2 serial number and software revision
For systems with two control heads, each head has its own serial number
located at the back of the unit. You can view this serial number at the
SECTION FOUR - Service/Maintenance
screen shows you the current
screen, then press the

Figure 30: Product information screen

screen, in the left-hand box of
field. The control head's software revisions are
screen for
Page 57