Unigas RG91 Manual page 26

PART II: INSTALLATION
alternating by an error message as:
To see the other Fault History pages, press the arrow keys.
To exit the Fault History pages, press ESC.
Lockout History
To visualise the Lockout History, choose the related item and press ENTER. The message will be:
alternating by an error message as:
To see the other Lockout History pages, press the arrow keys.
To exit the Lockout History pages, press ESC.
Setting the temperature/pressure set-point value
To set the temperature/pressure set-point value, that is the generator operating temperature/pressure; proceed as follows.
From the main page, enter the main menu by pressing the ESC key twice:
by means of the arrow keys, select "Params&Display", press ENTER: the system will ask you to enter the proper password
by means of the arrow keys, select "Access w-out pass" (access without password - user level), confirm by pressing ENTER.
The other levels require password reserved to the Technical Service, to the Manifacurer, etc.
The menu shown accessing without password is the following:
Choose "LoadController" and press ENTER: the following menu is shown:
O2 control and
limiter automat
deactivated
1 10.08.07
C:71 D:00
Start No.
Load 0.0
No flame at end
of safety time
OperationalStat
Operation
ManualOperation
Params & Display
Access w-out PW
Access Serv
Access OEM
Access LS
BurnerControl
RatioControl
O2Contr./Guard.
LoadController
26
13.47
F: 12
88
Gas