Alternate Procedure If Using A Crossover Cable - Nortel 1000 Hardware Installation Manual

6
7

Alternate Procedure if Using a Crossover Cable

1
2
3
If they are not correct, type n when asked to commit your changes, then
type 0 (Express Setup) to change settings.
To test the connection, verify that the Application Gateway can ping
connected network devices: Type 1 (Ping), press Enter, and enter the IP
address that you want to ping.
If the ping is successful, you have completed the initial configuration. If
the ping is not successful, check your connections, return to the serial
console Main Menu, and type 0 (Express Setup) to change settings as
needed.
Install licenses as described in
Refer to the Application Gateway Administration Guide for additional
operating information. You can download all documentation from the
Application Gateway Administration Tool.
If you prefer to use the Web-based Administration Tool rather than a serial
console to change the network settings of the Application Gateway,
perform the following steps to connect, power up, and configure the
Application Gateway.
If Application Gateway does not already have 1 GByte of memory, follow
the instructions in
Connect the Application Gateway power cord.
Check that the power cord is the type required in the region where the
a.
Application Gateway is used.
Do not modify or use the supplied AC power cord if it is not the
correct type. Refer to Installation and Configuration guide for your
call server for a detailed power cord description.
Attach the female end of the power cord to the AC power receptacle
b.
on the left side of the Application Gateway back panel. See
on page 22. Plug the male end of the AC power cord into the AC power
source (wall outlet).
Insert the Application Gateway CD-ROM into the CD-ROM drive.
Chapter 3 Hardware Installation and Initial Configuration
Connecting and Powering up the Application Gateway
"Installing Licenses," page
Appendix A, "Upgrading
Application Gateway Hardware Installation Guide
29.
Memory".
Figure 11
27