Table of Contents
Advertisement
Supported Platforms
Using this Manual
R
ead this guide if you will use Remote Annex Network Software for
Windows to configure and manage Bay Networks™ Remote Annexes.
This software includes:
•
Remote Annex Server Tools for Windows NT version 3.0
•
NA command line interface version 3.0
•
Quick2Config Annex version 3.0
You should be familiar with:
•
IBM compatible PC terminology and operation
•
Windows NT 3.51, Windows NT 4.0, or Windows 95
•
Networking terminology
Remote Annex Network Software for Windows NT runs on a variety of
Microsoft Windows platforms, including Windows NT 3.51 and 4.0, and
Windows 95. Specific platform support and requirements are discussed
in Chapter 1.
We have organized this manual follows:
•
Chapter 1 describes Remote Annex Network Software for
Windows, and the hardware and software you need to install
each module.
•
Chapter 2 describes use of the Setup program to load Remote
Annex software on a Windows NT Server 3.51 or 4.0. The
chapter can also be used as a guide for installing Quick2Config
Annex and NA on Windows 95 and Windows NT Workstation.
Installing Remote Annex Network Software for Windows
Preface
ix
Advertisement
Table of Contents
