Table of Contents
Advertisement
Figure 3-17. Quick2Config Call Defaults Tab
2.
Set the mode to AutoDetect.
AutoDetect enables incoming calls to be recognized as CLI, ARAP or
PPP.
3.
Leave the Subnet Mask set to 0.0.0.0.
4.
Set the Local Address to match the IP Address of the RA6300.
5.
If you are using AppleTalk, enter the Node ID in the AppleTalk
box.
6.
Enter the login argument in the Rlogin/Telnet box if appropriate.
7.
Choose the interface protocols to be negotiated when the dial-in
is using PPP.
Installing Remote Annex Network Software for Windows
Chapter 3
Configuration Examples
3-19
Advertisement
Table of Contents
