General Cutting - Power Fist 8567356 User Manual

V4.0 3 in. 3.5A Electric Cut·Off Tool 8567356
6. All bystanders are well clear of the area.
Failure to observe these safety rules will significantly increase the risk
of injury.
GENERAL CUTTING
DANGER! Always clamp the workpiece firmly into a vise or to a stable
work surface. Never hold the workpiece with one hand and the tool
with the other hand. Severe injury may result.
WARNING! Always wear appropriate eye, ear and breathing protection
and protective clothing when operating the cut-off tool.
1. Mark the workpiece where the cut is to be made.
2. Firmly clamp the workpiece in a vise or to a stable work surface.
3. Grasp the tool with both hands, turn the tool ON and wait until it
reaches full speed.
4. Carefully place the edge of the cutting disc onto the
workpiece surface.
5. While cutting, keep the tool moving over the workpiece, while
maintaining a steady pressure on the cut-off disc.
NOTE: Do not force the tool by applying too much pressure. The tool
will slow down and will not cut properly. It will also damage
the motor.
6. When the cut is completed, release the ON/OFF switch and allow the
cut-off disc to come to a complete stop before putting the tool down.
Visit www.princessauto.com for more information 17