Table of Contents
Advertisement
8
Operation
Notice
Local settings on the device take precedence over settings on the System
Access Point.
8.1
Control elements
Fig. 30:
Control elements
[1] Short press: Change fan speed level (0>1>2>3>Auto>0).
[2] Short pressure: reduce temperature by 0.5°C; long pressure: reduce temperature continuously.
[3] Short pressure: increase temperature by 0.5°C; long pressure: increase temperature continuously.
[4] Short press: set ECO mode; long press: change unit display (Fahrenheit/Celsius).
[5] Short press: switch the device on or off; long press: change the heating/cooling operation mode.
Switching the device on or off
Notice
–
1. Switch the device on or off with a press of the push-button [5].
–
The device switches to the setpoint display when switched on.
–
The device switches into frost/heat protection mode when switched off.
Setting of the setpoint temperature
Notice
–
–
Press button [2] to increase the setpoint temperature.
–
Press button [3] to reduce the setpoint temperature.
Setting of Fan speed
1. Press the button [1] until the desired fan speed level is set.
–
The fan speed level that is set is shown on the display.
Product manual 2CKA001373B8563
The device operates in frost/heat protection mode when switched off.
The set-point temperature appears automatically on the display. The device
must be switched on for this to happen.
Operation
│41
Advertisement
Table of Contents
