Table of Contents
Advertisement
Identification via switching
If several devices are listed in the device list, you can identify them by switching the actual
device.
Fig. 22:
Identification via switching (example illustration)
1. Open the device list.
2. Press the "Identification" button [1] and then switch the actual device.
Or, as alternative, press only button [2] in the web interface.
–
The connected load is switched.
–
The device is then selected automatically in the device list.
Switching of the device with the programming button
To switch the device, you can use the programming button on the bottom of the device. Use a
suitable tool with a diameter smaller than 2 mm. Press the tool into the programming button to
switch the device.
Specifying a name
1. Enter a name in text field [3] under which the application is to be displayed later, (e.g.
"Heating cellar").
2. Tap the "Save" button to take over the adjustments.
–
This takes over the entry.
Notice
The settings of the device can be adjusted via the Web-based user interface of
the System Access Point.
For pre-programmed devices the default settings can be adjusted. This allows
the channel selection to be influenced. For these settings, however, a fitter
access is partly necessary. The parameter settings remain as described above.
Product manual 2CKA001373B8563
Commissioning
│28
Advertisement
Table of Contents
