Installation - Victron energy EV Charging Station Manual

3. Installation

This product may only be installed by qualified personnel (licensed electrician).
It is suitable for wall mounting or pole mounting (vertical surface). In all cases, the surface should be solid and flat.
Precautionary measures
• Ensure that the AC input is protected by a fuse or magnetic circuit breaker rated at 40A or less. The
cable cross-section must be sized accordingly. If the AC input supply is rated at a lower value, the fuse or
magnetic circuit breaker should be sized accordingly.
• For charging at 22kW we recommended a 40 amp RCD type B protected supply.
• Recommended cable cross-section is 6mm² / AWG 10.
• Inside the device is a sticker with the model, serial number, WiFi password and, depending on the date of
manufacture, the unique Bluetooth pairing code. Note the password and pairing code on the internal label
for future reference. This initial password can be used for both logging in on the web page but also for WiFi
connection.
• The tightening force of the screws on the backing plate should be 1-1.2 Nm.
• The mounting surface should be solid and flat.
• Make sure you always have the latest version of this manual, which is updated regularly and available on
the EV Charging Station
Installation steps:
1. Remove the black backing plate by unscrewing the 8 screws.
2. Mark the wall where it should be mounted using the removed backing plate as a template.
3. Drill 4 holes with wall plugs ready for installation.
4. Measure a suitable location and drill through the wall for the cable (when main supply cable comes from inside the building).
5. Label each individual cable and pass it through the wall, the nylon gland, the grommet and into the charging station.
6. Terminate the cable ends with ferrules and connect to the relevant points.
7. If this is a single-phase installation, use L1, neutral and earth connections.
8. Tighten the nylon gland around the cable.
9. Reattach the black plate to the charging station and tighten the 8 screws.
10. Mount the station on the wall.
Watch this video for an installation example:
Page 4
Manual - EV Charging Station
website.
Installation