Does The Display Show This Message; Memory Reset - Nortel Meridian Companion Installation And Maintenance Manual

Does the display show this message?

Memory Reset

Memory Reset reinitializes the system, erasing any existing system memory
and resetting it to the factory default values.
You must enter the Memory Reset code no later than 15 minutes after the
Meridian Companion system has been powered up. If you enter the Memory
Reset code at any time after the 15-minute interval, you hear an error tone, and
the display shows Startup denied. If 15 minutes have elapsed since you
powered up the system, remove and reinsert the CMCC to prepare for Memory
Reset.
Performing Memory Reset
1.
2.
If display shows
Config Ambiguous
Only the installer should perform Memory Reset.
Memory Reset erases all system data and clears all active calls.
The registration information is part of the system data. If this data
is erased, your portables will not work properly.
Press ƒ , then ••
Enter the Installer password. The default password is ‚‚‚‚ .
If the password is correct, the display shows Erase all data? .
Meridian Companion Installation and Maintenance Guide
System initialization Page 71 of 206
and the system
contains CMBC
ATTENTION!
⁄
. The display shows
then
Ensure a Base Station is
connected to the CMBC.
See Table 41 on page 174.
Password:
.