Nortel BCM50 Documentation Update page 5

In order for the SRG 50 to act as a SIP endpoint and to use the SIP Trunks for call signaling with the CS 1000, you
must configure SIP Trunks between the SRG 50 branch office and the CS 1000 Release 5.0 main office. For
information about configuring SIP Trunks for SRG 50, see SRG 50 Configuration (NN40140-500). The following
procedure refers to SIP Trunk configuration for the CS 1000 Release 5.0 main office.
Configuring SIP Trunks at the main office
1. From the Element Manager navigator, click IP Network > Nodes: Servers, Media Cards.
The Node Configuration window appears.
2. Click the Edit button associated with the node to be updated.
3. Click the plus (+) sign beside Signaling Server Properties.
4. From the Enable IP Peer Gateway (Virtual Trunks TPS) list, select SIP only.
5. Enter the CS 1000 domain name in the SIP Domain Name field.
6. Enter the SIP Port number in the Local SIP TCP UDP Port to Listen to field.
7. Enter the Signaling Server name in the SIP Gateway Endpoint Name field.
8. Click Save and Transfer.
The Save and Transfer window appears.
9. Click OK.
10. Log on to Network Routing Service (NRS) Manager.
BCM50 3.0 Documentation Update
The Signaling Server is configured as
SIP only endpoint.
SIP Port
CS 1000 main office domain name
Endpoint name is configured as the
Signaling Server name.
NN40020-400
5