Factory Settings - Eaton CROUSE-HINDS Series Instruction Manual

Eaton InduTel IP4 Instruction manual

Factory settings

To reset the device to factory settings, disconnect the power supply, press and hold
the button, restore the power supply and hold the button pressed for 7 – 10 seconds
(some PoE supplies take some time to turn on the power supply. This lead time must be
added to the holding time.)
If you do not press and hold the button long enough, the phone may start the
BOOTCODE with minimal firmware. Fig. 20 shows a BOOTCODE that has started.
Figure 20 . Started minimal system
In this mode, the telephony function and the corresponding settings are not available.
To get back to normal mode, restart the telephone.
InduTel IP4 InsTrucTIon manual TMF037.A January 2023 www.eaton.com 21