General Operating Instructions - Eaton CROUSE-HINDS Series Instruction Manual

Eaton InduTel IP4 Instruction manual

General operating instructions

1. All IP addresses shown in illustrations in this
document are mere examples and will vary
depending on the network structure and setup.
2. InduTel IP is a VoIP (Voice over Internet Protocol)
telephone and is operated on a 10/100/1000 BaseT
Ethernet network. Various protocols are available
for the connections. Operation corresponds to that
of an analogue telephone.
3. Power is supplied via Power over Ethernet (PoE)
from the network or via a separate DC voltage
source. Only one power supply may be connected
at a time.
4. Programming and parameterisation are exclusively
via the web server of the telephone. This can be
reached via the standard web browser of a PC. To
access the web server, the username and password
must be entered. The factory settings for the
username and password are:
Username: admin
Password: ip161
The device is pre-set to DHCP client mode.
5. The telephone has a cradle with magnetic
contact as a hook switch. To terminate an existing
connection, the handset must be hung up. Pressing
the disconnect button in the keypad is sufficient for
interrupting an existing connection.
4 InduTel IP4 InsTrucTIon manual TMF037.A January 2023 www.eaton.com
6. The internal relay contacts only allow switching
of voltages up to 30 V
permissible current depends on the operating
mode (see chapter Technical data)
7. A housing connector enables connection to the
network (LAN).
8. The handset of the phone is equipped with a stray
field coil for coupling with hearing aids. Those
wearing a hearing aid with an inductive receiver
can receive the signal from the hearing capsule
directly through the hearing aid.
or 53 V . The maximum
AC DC