Nortel Versalar 15000 Troubleshooting Manual page 8

Known Anomalies for the Versalar Switch Router 15000
BCC Commands
Title:
Number:
Description: If you repeatedly press the Enter key on the console PC or terminal keyboard
immediately following a boot command, the Versalar 15000 may enter diagnostic
monitor mode.
Workaround: Enter the boot command again, at the diagnostic monitor prompt.
Title: Cannot Source a Config File Containing an IGMP Static Group
Number:
Description: If you configure an IGMP static group, save the configuration to a file, and use the
source
Specified interface is not a configured local IP address on this
box.
IGMP#
Workaround: For IGMP, add static groups at the end of the source file.
Title: Multiple Show Command Sessions Not Supported
Number:
Description:
execute a BCC
command until you complete the session. If another user attempts to execute a BCC
show
command hangs.
BCC Help
Title: Help on the unnumbered-circuit-name Parameter Is Missing [New]
Number:
Description: BCC help for the IP
unnumbered-circuit-name
next-hop-mask parameter for the
Workaround: Help for the
should provide the following definition:
The name of the local router circuit associated with the static
route over an unnumbered interface.
4
The Versalar 15000 May Enter Diagnostic Mode Erroneously [New]
128117-1
122302-2
command to load the file, the following error message will appear:
91586-1
The BCC currently supports only one active
command, no other user can successfully issue a
show
command while your
130580-1
static-route
unnumbered-circuit-name
show
command is paused, the other user's
show
object is missing information for the
parameter. In addition, the help incorrectly refers to a
static-route object; no such parameter exists.
parameter for the IP
command session at a time. If you
show
show
static-route
302773-E Rev 00
object