Nortel Versalar 15000 Troubleshooting Manual page 15

Title:
Number:
Description:
Title:
Number:
Description:
Workaround:
Title:
Number:
Description:
Title:
Number:
Description:
ATM
Title:
Number:
Description:
302773-E Rev 00
QoS Receive Parameter Capabilities Do Not Support T3 Levels [New]
112497-2
QoS capabilities do not support T3 levels for either the
parameter for a QoS queue.
rx-burst-rate
Wrong Line Type Displayed for Dual MCOC-3 Multimode Module
111403-1
The
show oc3 summary
OC-3 multimode module as "shortsinglemode."
Enter the
show hardware slots
representation of the line type.
T3 Clear Channel FEAC Line Loop Deactivate Code Does Not Work on DL3100
DSU
105688-1
If you set the
send-feac-loop-code
Link (DL) 3100 data service unit (DSU) does not respond, and line loopback
generation remains enabled. (Note that the acronym FEAC indicates far end action
code.)
T3 Framing Autodetect Has Difficulty Stabilizing on ADC Kentrox from C-bit
to M13
105666-1
If you dynamically configure C-Bit to M13 framing on an ADC Kentrox CSU/DSU,
the T3 clear channel and T3 hybrid services become unstable. You may experience
from 3 to 12 mismatch/withdraw/providing service log messages before the clear
channel T3 and hybrid T3 services become stable.
ATM Traffic Shaping for VBR Intermittently Allows Bursts Above the
Configured Rate [New]
127628-1
ATM traffic shaping for transmissions on a virtual channel connection (VCC) using
variable bit rate (VBR) service may intermittently exceed the configured transmit
maximum burst size (MBS). On average, one or two cells exceed the MBS. These
cells are marked as discard eligible and are dropped when congestion occurs.
Known Anomalies for the Versalar Switch Router 15000
command displays the Line Type dual mode channelized
command and refer to "Module" for an accurate
parameter option to
parameter or the
rx-cir
, the Digital
deactivateall
11