EASTMAN Kodak X-Omat 5000 RA Operator's Manual page 74

OPERATORS MANUAL
[5] From the Walk-Up Menu, press the "GO TO SETUP" key.
READY
[6] Enter the 4-digit access code.
[7] Press the "MORE" key.
[8] Press the "OPTIONS" key.
[9] Press the "REPLEN MODE" key.
Important
• If the developer and fixer Tanks of the Processor are empty and you do not press "TANK FILL," a "Fill Error" will
occur in approximately 4 minutes.
• The developer and fixer Tanks will not fill if the Top Cover is removed.
• The developer and fixer Tanks require approximately 10 minutes to fill with solution.
• A Tank Fill error message will appear on the Display Panel while the Tanks are filling.
• Once the Tanks are full, the Replenishment Pumps automatically turn off and the normal, Processor warm-up
period begins.
[10] Press the "TANK FILL" key.
[11] Press the "DONE/RETURN" key repeatedly until you return to the Walk-Up Menu.
[12] If you are using RP chemicals, wait until the Tanks have been filling for approximately 1 minute. Then
add 250 mL (8.5 fl oz) of starter solution to the drive side of the Processor's developer Tank.
[13] After the Replenishment Pumps stop operating, check that:
(a) the level of both the developer and fixer solutions in the Tanks is at the overflow limit.
(b) there is some movement on the surface of the developer and fixer solutions to indicate that the
Recirculation Pump is operating.
74
DRYER SLEEP
TEMP
1 2
INFO SETUP
REPLEN DAILY
MODE STARTUP
AUTO FLOODED
SELECT MORE
CYCLE
3 4
CHEM/ MORE
CYCLE
OPTIONS
DISPLAY MORE
UNITS
TANK FILL DISABLE
REPLEN
STD
GO TO
SETUP
CANCEL
REQUEST
DONE/
RETURN
DONE/
RETURN
DONE/
RETURN
DONE/
RETURN
May 1997 – 5B6729