EASTMAN Kodak X-Omat 5000 RA Operator's Manual page 42

OPERATORS MANUAL
[7] One of the following 2 screens will appear. Press the key for the desired film processing cycle.
PRESS BUTTON TO SELECT
PRESS BUTTON TO SELECT
[8] Press the "TEMP" key.
[9] Press either key:
• the "DEV TEMP" key to change the developer setpoint temperature
• the "FIX TEMP" key to change the fixer setpoint temperature
[10] To change the setpoint temperature, press the appropriate key:
• [ ] key to increase the setpoint temperature
• [ ] key to decrease the setpoint temperature
• [DEFAULT SETTING] to return to the default setpoint temperature
• [CANCEL REQUEST] to cancel the procedure
95.0 F = DEVELOPER SETPOINT
[11] Do Steps 9 and 10
[12] Press the "DONE/RETURN" key repeatedly until you return to the display shown below. Then press the "YES"
key to return to the Walk-Up Menu.
EXIT SETUP?
Note
The setpoint temperature for the fixer solution is a minimum only; the temperature may rise above this setpoint.
42
RAPID STD CYCLE
CYCLE
K/RA
CYCLE
TEMP REPLEN
VOLUME
DEV FIX
TEMP TEMP
for the fixer (or the developer) solution.
YES
EXTD
CYCLE
SPEED
DEFAULT CANCEL
SETTING REQUEST
DONE/
RETURN
DONE/
RETURN
DONE/
RETURN
DONE/
RETURN
STD
DONE/
RETURN
CANCEL
REQUEST
May 1997 – 5B6729