Return To Supplier; Storage - Danfoss PAHT C Installation, Operation And Maintenance Manual

Operation guide | Installation, Operation and Maintenance Manual for PAHT C 2-6.3 pumps
Pumps which have a weight above 20 kilos (see
appendix 1, Data sheet) must be handled by
using lifting eyes and slings .
Never use only one sling and make sure the
slings does not slip off the pump .
When the pump is mounted together with an
electric motor, the pump unit always weigh more
than 20 kilos and must be handled by using
slings around the pump unit .
See below examples of where to/not to attach
the lifting slings on the pump unit:
Correct lifting with 2 separate slings:
180R9316 | AQ176586503002en-000501 | IOM PAHT C 2-6.3 pumps | 01.2022
Wrong lifting:
When lifting the pump unit, one sling must be
attached to the electric motor and one sling
around the pump .
Only some motors and pumps have specific
lifting eyes .
Do not use connections/nozzles for lifting!
Do not use only one sling!
Make sure that the unit/load is balanced before
lifting . The centre of the mass varies from pump/
pump unit size to pump/pump unit .
How to mount the pump and the electric motor
correctly, see appendix 1, Data sheet or appendix
2, Instruction .
Incorrect lifting can result in personal injury
and/or damage to the pump unit, see appendix
2, Instruction.

4.5 Return to supplier

Please see maintenance chapter 7 .

4.6 Storage

Each pump is tested before shipment, and will
therefore contain water . For storage temperature
and frost protection see appendix 2, Instruction .
The pumps are NOT delivered frost protected
from the factory.
9