Bang & Olufsen BeoPlay V1-40 MKII Service Manual page 5

Handling and cleaning
Static electricity
STATIC ELECTRICITY
MAY DESTROY THE
PRODUCT
Static-protective field service kit
ESD
Symbol of safety components
Cleaning
Transport and handling
Service rods, service pins, protection sheet
Waste of Electrical and Electronic Equipment (WEEE)
Static electricity may damage the product.
A static-protective field service kit must always be used when the product is
disassembled or modules are being handled.
Follow the instructions in the guide and use the ESD-mat for both old and new
modules.
Please note:
ESD-Mat
When mains voltage on the product is required, remove the connection between
the product and the ESD-mat.
The chassis or modules must always be connected to the static-protective field
service kit or placed in an ESD-proof bag.
When replacing components with this symbol, the same type has to be used, also
the same values for ohm and watt.
The new component is to be mounted in the same way as the replaced one.
Please refer to the chapter "Final check after repair".
The product must not be transported placed on the screen.
It is recommended to use the product cover when transporting the television.
The product cover can be ordered.
Place the television lying on the LCD (front side) on an ESD-mat and dismount the
stand or bracket while replacing with service pins and service rods. See instructions
in chapter 5.
The protection sheets must be inserted as instructed to avoid scratching the
laquered surfaces.
Electrical and electronic equipment, parts and batteries marked with this symbol
must not be disposed of with normal household wastage; all electrical and
electronic equipment, parts and batteries must be collected and disposed of
separately.
Your Bang & Olufsen retailer will advise you of the correct way of disposal in your
country.
How to service 1.3