13.0 - Troubleshooting - Gemini 514FI User Manual

FAULTS
The system does not work when ignition is turned ON.
A sound signal goes off when there is no obstacle in
front of the vehicle.
No warning signals.
False warning signals.
The present device falls within the field of application of the current WEEE Directive. The crossed-out wheeled bin symbol on the equipment or on its packaging indicates that
the product, at the end of its useful life, must be discarded separately from other waste to allow adequate treatment and recycling.
The user must therefore take the equipment, at the end of its useful life, to an appropriate waste collection facility.

13.0 - TROUBLESHOOTING

If they read the ground, use the correction adapters to tilt the sensors upwards.
Check that there is no excessive paint on the sensor surface. Too much spray paint can impair sensor ability to function
Back part of sensors in contact with frame. Create a separation between the sensors and the vehicle chassis (at least
14.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
15.0 - TECHNICAL SPECIFICATIONS
Power supply
Current consumption – system ON
Operating temperature range
Ultrasonic frequency
Designed and manufactured by GEMINI TECHNOLOGIES srl ‐ Via L. Galvani, 12 – 21020 Bodio Lomnago (VA) – Italy
Tel. +39 0332 943211 – Fax +39 0332 948080 – www.gemini‐alarm.com
ISO 9001 CERTIFIED COMPANY
CAUSE / SOLUTIONS
Check all connections.
Check that the arrow and the UP indication are pointing upwards.
Ensure that the sensors have been installed at the correct height.
Modify setting.
Sensitivity might be too high. Adjust sensitivity.
properly.
Check connections.
2mm).
12 - 24 Vdc
10mA @12V
-40°C / +85°C
58 kHz
Rev.00 09/2022
9/9