Table of Contents
Advertisement
Before configuring the system, ensure all connections have been done properly.
Parameters must only be configured by qualified personnel.
Programming the parameters listed in par.11.0 is carried out using buttons "A" and "B" on the control unit (see figure below).
Press button "A" to select the parameter to configure.
Press button "B" to select the desired setting.
10.1 - HOW TO ENTER IN PROGRAMMING MODE:
1.
Turn ignition key "ON".
2.
Simultaneously press buttons "A" and "B" for approx 4 sec.
3.
1 Beep and 1 Green/Red LED flash will confirm entry in programming mode.
4.
Release the buttons and wait until the LED turns OFF.
10.2 - PARAMETER SETUP:
1.
Within 10 sec. after the LED turns OFF, press button "A" the number of times corresponding to the parameter to customize. At each button press there will be 1
Beep and 1 Red LED blink.
2.
Press button "B" the number of times corresponding to the desired setup. At each button press there will be 1 Beep and 1 Green LED blink.
Example: To set the inner sensors maximum detection distance at 90 cm => press button "A" twice and then button "B" 9 times.
10.3 - SETUP CONFIRMATION
:
1.
The control unit will repeat the number of Beeps and blinks corresponding to the selected setup. After a few seconds, a 'Jingle' will sound if the code has been
entered successfully.
2.
In case of an incorrect entry, a low tone signal (Bop) will sound and the system automatically exits programming.
3.
After the confirmation 'Jingle' other parameters can be configured by following the same procedure.
4.
If no button is pressed within approx. 10 sec., the system automatically exits the programming mode.
10.4 - RESTORE FACTORY SETTINGS
1.
Simultaneously press and hold buttons "A" and "B" and turn ignition ON.
2.
The LED will start blinking Green/Red.
3.
When the buzzer gives off a Beep, release buttons "A" and "B".
4.
When the LED stops blinking, a Jingle" will confirm the control unit has been reset to the original factory settings.
10.5 - SET ODOMETER PULSES:
Turn ignition key ON and set a speed threshold:
1.
Set parameter 51 before carrying out the subsequent programming.
2.
If pulses/meter are known, use the values indicated in the configuration table (par. 11.0).
3.
Otherwise program parameter "98" to allow the control unit to record the pulses. A Beep will confirm the control unit is in speed reading mode. Without turning
ignition key OFF, start the engine and drive a short distance. At the desired speed (we recommend 10 km/h), press the ON/OFF switch to confirm the reading.
A 'Jingle' will confirm the speed reading has been learned by the control unit.
10.0 - PARAMETER PROGRAMMING
Designed and manufactured by GEMINI TECHNOLOGIES srl ‐ Via L. Galvani, 12 – 21020 Bodio Lomnago (VA) – Italy
Tel. +39 0332 943211 – Fax +39 0332 948080 – www.gemini‐alarm.com
ISO 9001 CERTIFIED COMPANY
Rev.00 09/2022
6/9
Advertisement
Table of Contents
