Programming - 3T-Components 3T-MOTORS 3T45-20 Installation & Operating Instructions Manual

PROGRAMMING

The internal battery must be charged before programming.
Perform programming before mounting the motor and solar module.
One transmitter can control up to 20 solar modules. Receiver stores a maximum of 20 transmitters (channels).
Connect the shutter motor to the SP50 solar module:
Slide the rotary lock of the SP50 solar module connection to the rear.
•
Before connecting the connecting cables, make sure that the markings (arrow) are opposite each other.
Connect solar module SP50 and shutter motor together.
•
Fix the connection of the cables with the twist lock. Close the twist lock tightly to prevent water from entering.
•
After programming, disconnect the connection cables again for mounting.
•
1
Connection Connection
SP50 tubular motor
Pairing of handheld transmitter to
SP50 solar module:
Tubular motor
starts 1 x
Press and hold program
button for 2 sec.
programm button
Note:
When programming, make sure that the direction of rotation of the motor is correct.
This means that the direction of rotation does not have to be changed after assembly.
> fig. 2
2
LED indicator
flashes 1 x
1 x Press button
Release
P2 / Set Up
3
Twist lock
Programming (pressing the buttons) must be carried out within 10 seconds.
Otherwise the system returns to its original state.
LED indicator LED indicator
flashes 1 x flashes 1 x
1 x Press button
P2 / Set Up
> fig. 1
> fig. 3
Tubular motor starts 1 x,
LED indicator flashes 4 x
1 x press Up-button
or
Tubular motor starts 1 x,
LED indicator flashes 4 x
1 x press Down-button
3T-MOTORS Tubular motors 12V | Programming
OK
Transmitter is paired
Up-button controls
motor forward
OK
Transmitter is paired
Down-button controls
motor forward
6