PROGRAMMING
Delete all paired transmitters
2
Tubular motor starts 1 x,
LED indicator flashes 1 x
1 x Press button
P2 / Set Up
Reset to factory setting:
Tubular motor
Press and hold program
button for 11 sec.
Restoring the factory setting will delete all settings and transmitters!
The solar panel then automatically goes into sleep mode. No programming can be carried out in the sleep mode.
To end the sleep mode, press and hold the program key for 2 seconds > the tube motor starts up once and the solar panel switches to pairing mode.
Note:
The following 3T-MOTORS transmitters do not have a P2 / Set Up button:
Radio mini transmitter
Radio wall transmitter
FMSF
Button combination:
Press Up + Stop buttons simultaneously (FMSF / WS1 / WS2 / WSE2).
Press the Set and Mode buttons simultaneously (WSTF1 / WSTF5).
1 x Press
Stop-button
starts 3 x
Release
programm button
Radio wall transmitter
WS1
WS2
LED indicator
flashes 1 x
1 x Press button
P2 / Set Up
Programming (pressing the buttons) must be carried out within 10 seconds.
Otherwise the system returns to its original state.
LED indicator
flashes 3 x
Radio wall transmitter
WSE2
Tubular motor starts 1 x,
LED indicator flashes 4 x
Radio timer
WSTF1
3T-MOTORS Tubular motors 12V | Programming
OK
All transmitters
are deleted
OK
Reset to
factory setting
Radio timer
WSTF5
8