Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Slide the side bearing with universal bearing onto the support tube & fasten.
•
Ensure that the motor square spigot is properly engaged in the universal bearing.
•
Secure the motor square spigot with the supplied cotter pin.
•
Attach the cover to the side bearing.
•
Install awning & release fuses.
•
3.9
Support tube
Side bearing &
Universal bearing
Mount solar module SP50:
4
Mount the solar module to the wall or roof using one of the following options:
•
Mounting with 2 wall brackets:
SP50 Rear with wall brackets
1
3
2
Insert the wall brackets (1) into the fasteners and secure them
•
with the screws (2) supplied.
Fix the fastenings with the supplied grub screws (3) at the desired
•
position with hexagonal wrench.
Mount the wall brackets on the wall with the supplied dowels and screws.
•
Connection roller shutter motor + solar module SP50:
5
Connect cables of shutter motor and solar module SP50 (see description page 6).
•
If the drive should run in the opposite direction after installation, the direction of rotation must be changed via the solar panel SP50.
•
(see programming page 7).
>
fig. 3.11
>
fig. 3.12
3.10
1
3
2
>
fig. 3.9
>
fig. 3.10
3.11
Cotter pin
Mounting with clip bearing:
SP50 Rear with clip bearing
Attach the clip holder (1) to the wall or roof with suitable screws and dowels.
•
When doing so, take the desired angle into account.
Snap the solar module into the clip holder.
•
3.12
Cover
1
3T-MOTORS Tubular motors 12V | Installation instructions
Side bearing
18
Advertisement
Table of Contents
