Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
On the opposite side of the motor, push the roller capsule out of the roller shutter shaft until it fits into the ball bearing inserted in the wall bearing.
•
Fix roller capsule to roller shutter shaft with self-tapping screw. Position the screw at a punched hole. This prevents the screw from slipping.
•
Roller capsule
Mount solar module SP50:
7
Mount the solar module to the wall or roof using one of the following options:
•
Mounting with 2 wall brackets:
SP50 Rear with wall brackets
1
3
2
Insert the wall brackets (1) into the fasteners and secure them
•
with the screws (2) supplied.
Fix the fastenings with the supplied grub screws (3) at the desired
•
position with hexagonal wrench.
Mount the wall brackets on the wall with the supplied dowels and screws.
•
Connection roller shutter motor + solar module SP50:
8
Connect cables of shutter motor and solar module SP50 (see description page 6).
•
If the drive should run in the opposite direction after installation, the direction of rotation must be changed via the solar panel SP50.
•
(see programming page 7).
Mounting with clip bearing:
1
3
2
Attach the clip holder (1) to the wall or roof with suitable screws and dowels.
•
When doing so, take the desired angle into account.
Snap the solar module into the clip holder.
•
Wall bearing +
Ball bearing
SP50 Rear with clip bearing
1
3T-MOTORS Tubular motors 12V | Installation instructions
13
Advertisement
Table of Contents
