Table of Contents
Advertisement
NOTES ON THE SETTTING OF THE MOTOR
Important explanations on setting and programming the motor.
Please read carefully before setting the motor.
Programming:
The programming interval for radio transmitters is 6 seconds. After 6 seconds, the radio transmitter terminates programming.
•
The radio motor confirms programming steps with beeps
•
Setting the end positions:
After the end points have been set, they cannot be saved at the same position when readjusting.
•
After setting the endpoints, they are saved in case of power failure.
•
When the endpoints are deleted, the upper and lower endpoints are deleted.
•
The programming of the end points is terminated after 2 minutes if no commands are received.
•
Number of programmable radio hand-held transmitters:
The radio motor can store up to 20 radio handheld transmitters / radio transmitters.
•
If additional transmitters are stored, the transmitter that was paired first will be overwritten.
•
FUNCTIONS P1 BUTTON
1. Pairing handheld transmitter / Pairing additional handheld transmitters:
Press button P1 once
2. Change the direction of rotation of the radio motor:
3 x beep from motor + down and up
Press P1 button for 5 sec. + keep pressed
3. Reset motor settings:
3 x beep from motor + down and up (after 5 Sec.)
after that 3 x beep from motor + down and up
Keep P1 button pressed
and a short down and up
+
1 x long beep from motor + down and up (no handheld transmitter paired)
3 x beep from motor (pairing of further handheld transmitters)
+
+
+
, perform the next step after the hint.
Release P1 button
Release P1 button
(after 8 Sec.)
3T-MOTORS Radio tubular motors | Notes on the setting of the motor
The motor is ready
for pairing a handheld
transmitter / further
handheld transmitters
The direction of rotation
of the motor is changed
down and up
All motor settings
are reset
14
Advertisement
Table of Contents
