H3C S6805 Series Troubleshooting Manual page 52

WGE1/0/50
1
WGE1/0/51
1
WGE1/0/52
1
WGE1/0/53
1
WGE1/0/54
1
WGE1/0/55
1
WGE1/0/56
1
GE1/0/57
1
GE1/0/58
1
M-GE0/0/0
0
M-GE0/0/1
0
The output shows that WGE 1/0/1 is associated with chip port xe3.
# Execute the bcm slot 1 chip 0 show/c/xe3 command to check the RDBGC and TDBGC
fields for Rx and Tx dropped packet statistics, respectively. The statistics displayed were
generated between the last and the current execution of the command. To view the change
in dropped packet statistics, execute the command twice or more.
[Sysname-probe] bcm slot 1 chip 0 show/c/xe3
RDBGC2.xe0
R511.xe0
RPKT.xe0
RMCA.xe0
RPOK.xe0
RBYT.xe0
T511.xe0
TPOK.xe0
TPKT.xe0
TMCA.xe0
TBYT.xe0
PERQ_PKT(3).xe0
PERQ_BYTE(3).xe0
2. Verify that packets are not mistakenly filtered out by ACLs:
a. Examine the ACL and QoS policy configurations for packet filtering on the port, on the VLAN
of the port, or globally. If packets are mistakenly filtered out, modify the ACL or QoS policy
configuration.
−
To display the ACL configuration on the port for packet filtering, execute the display
packet-filter command.
−
To display the QoS policy configuration on the port, execute the display qos policy
command.
0 102 xe45
0 99 xe42
0 100 xe43
0 109 xe48
0 110 xe49
0 107 xe46
0 108 xe47
0 66 ge0
0 130 ge1
0 136
0 137
: 8,118
: 8,118
: 8,118
: 8,118
: 8,118
: 2,726,553
: 8,208
: 8,208
: 8,208
: 8,208
: 2,741,472
: 8,208
: 2,741,472
49
no no 0x52
no no 0x53
no no 0x54
no no 0x55
no no 0x56
no no 0x57
no no 0x58
no no 0x59
no no 0x5a
no no 0x5a
no no 0x5a
+8,118
+8,118
+8,118
+8,118
+8,118
+2,726,553
+8,208
+8,208
+8,208
+8,208
+2,741,472
+8,208
+2,741,472
16 down
16 down
16 down
16 down
16 down
16 down
16 down
16 down
16 down
16 up
16 down
330/s