T Select Tone Dialling; Define Dce Response Format; Result Code Selection; Z Reset To Default Configuration - Nokia 8850 Command List

T Select Tone Dialling

V Define DCE Response Format
X Result Code Selection

Z Reset to Default Configuration

AT Command Set for Nokia 8850
This setting is ignored. It is included for compatibility reasons. (V.25ter section 6.3.2.)
Syntax:
ATT
This command determines whether result codes are transmitted in a numeric format
or an alphabetic (or verbose) format. (V.25ter section 6.2.4.)
Syntax:
ATV[0]
ATV1
This command selectively enables or disables the response codes sent to the DTE.
When BUSY, NO ANSWER, DELAYED or BLACKLISTED is not enabled, NO
CARRIER is used instead. When CONNECT <rate> with a correct data <rate> is not
enabled, a plain CONNECT is used instead. This command does not affect the
presentation of other result codes than the ones mentioned below. (V.25ter section
6.2.7.)
Syntax:
ATX[0]
ATX1
ATX2
ATX3
ATX4
ATX5
This command restores the parameter values of one of the user profiles by recalling
the respective settings from the memory. Settings that are not stored in a profile (see
command &W, page 10) will be reset to their factory defaults (see command &F,
page 9). If the product does not have memory profiles (or has only one of them) it
shall accept both the command Z0 and Z1 (and reset to factory defaults). (V.25ter
section 6.1.1.)
Syntax:
ATZ[0]
ATZ1
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
Select numeric (short form) responses.
(Numeric V.25ter basic syntax result
codes with limited headers and trailers.)
Select textual (long) responses. (Verbose
V.25ter basic syntax result codes with full
headers and trailers.) This is the default
option.
OK, CONNECT, RING, NO CARRIER,
ERROR codes enabled.
also CONNECT 1200, CONNECT 2400
enabled.
same as value 1
also BUSY enabled
also NO ANSWER enabled
also CONNECT 4800 (or higher data
rates), CARRIER, DELAYED,
BLACKLISTED enabled. This is the
default option.
Disconnect, reset to stored profile 0.
Disconnect, reset to stored profile 1.
52