L Monitor Speaker Loudness; M Monitor Speaker Mode; O Return To On-Line Data State; P Select Pulse Dialling - Nokia 8850 Command List

L Monitor Speaker Loudness

M Monitor Speaker Mode

O Return to On-Line Data State

P Select Pulse Dialling

Q Result Code Suppression

S0 Automatic Answer

S1 Ring Count

S2 Escape Code Character

AT Command Set for Nokia 8850
This setting is ignored. It is included for compatibility reasons. (V.25ter section
6.3.13.)
Syntax:
ATL[<n>]
This setting is ignored. It is included for compatibility reasons. (V.25ter section
6.3.14.)
Syntax:
ATM[<n>]
This command is used when you have made a connection with the remote device
and have escaped (with the +++ command) to the command mode. Give the
command to return from the (on-line) command mode to normal on-line operation.
(V.25ter section 6.1.2.)
Syntax:
ATO[<n>]
This setting is ignored. It is included for compatibility reasons. (V.25ter section 6.3.3.)
Syntax:
ATP
This command determines whether responses are sent to the DTE or not. Affects
only result codes, not information responses. (V.25ter section 6.2.5.)
Syntax:
ATQ[0]
ATQ1
Value indicates number of rings (RING or +CRING result codes) to wait before
answering automatically. Value 0 disables auto-answer. (V.25ter section 6.3.8.)
Syntax:
ATS0=<n>
ATS0?
Returns number of rings (RING or +CRING result codes) counted after last MT call
setup. (De facto.)
Syntax:
ATS1?
The default character is a plus sign. See also the command +++ Escape at page 10.
(De facto.)
Copyright © 2000. Nokia Mobile Phones. All rights reserved.
L[0]...L3
M[0]...M2
Go to on-line state. Response is
CONNECT [<speed>].
Enable sending of responses to DTE. This
is the default option.
Disable sending of responses to DTE
Values for <n> are 0..255 (default 0).
Query current setting.
Response is <n>.
Query current setting.
Response is <n>. Values for <n> are
000..255.
49