Introduction - Nokia 8850 Command List

At command set

Hide thumbs Also See for 8850:

Table of Contents

AT Command Set for Nokia 8850

Introduction

This document describes the AT commands supported by Nokia 8850. A short

description, the syntax, the possible setting values and responses of the AT

commands are presented.

Computers use AT commands to communicate with modems. Most communications

applications, however, have a user friendly interface that hides these AT command

from the user. You issue AT commands via your communications application. When

the software in the Nokia product has received an AT command, it responds with a

message that is displayed on the screen of the device you are using. Some

command parameters may not be supported by the phone, and using those

parameters causes an error response.

Note that the "AT" or "at" prefix must be included at the beginning of each command

line.

Table of Contents