Site Preparation - Demtech Pro-Tester T-0100 Operator's Manual

DEMl)Cii
Rev B: December 2006
2. Site Preparation
Before proceeding with the installation instructions in the following section( s) make sure the
work site is prepared and ready to install the Pro-Tester™. You should have an adequate power
source capable of provided clean Alternating Current (AC) power at
110
or 220 Volts at the rated
current. Refer to the system serial plate affixed to the rear of the system for the voltage and
current requirements of your system. The install area should be clean, dry and free of debris and
provide adequate working area to allow efficient and effective use of the system.
Follow the detailed installation introductions carefully.
T-Manual RB
Pro-Tester™ Operator's Manual Page 2