Loading Samples - Demtech Pro-Tester T-0100 Operator's Manual

Rev B: December 2006
DEMl)Cii
3.3. Loading Samples
Loading samples is very simple with the Pro-Tester™. To load a sample open both jaws of
the sample grip assemblies. The left grip is a cam clamp and is opened by toggling the cam
handle to the right (open). The right grip is a screw clamp and is opened by unscrewing the
tri-handle counter-clockwise (open). The sample is prepared by bending the ends to be
clamped so they can be easily loaded into the grips. Load the sample from the top of the grip
until the sample rests against the stop tabs then apply the left and right grip clamps (refer to
Figure 3).
Stop Tab
Figure 3
Page 7 Pro-Tester™ Operator's Manual T-Manual RB