Braun ThermoScan IRT 6020 Manual page 8

Fully insert the probe into the ear canal and point
4
straight towards the opposite ear or temple.
Once positioned correctly, press and release the
start button
ExacTemp® Stability Indicator light will pulse while temperature is in progress.
5
The light will remain solid for 3 seconds to indicate that a successful
temperature reading has been achieved.
NOTE: If the probe has been properly inserted into the ear canal
during the measurement, a long beep will sound to signal the
completed measurement.
If the probe has NOT been constantly placed in a stable position in the
ear canal, a sequence of short beeps will sound, the ExacTemp® Stability
Indicator light will go out and the display will show an error message
(POS = position error).
See « Errors and troubleshooting » section for more information
6
The confirmation beep indicates that an accurate
temperature measurement has been taken. The
result is shown on the display.
7 For the next measurement, press Eject button
remove, and discard used lens filter, and put on a new,
clean lens filter.
The Braun ThermoScan Ear thermometer turns off
automatically after 60 seconds of inactivity.
The thermometer can also be turned off by
pressing and holding down the Power button
The display will briefly flash OFF and it will go blank.
6
.
to
.