Setting Of The Weighing Capacity / Minimum Division / Decimal Point Position - A&D FG-D-CWP Instruction Manual

7.2. Setting of the Weighing Capacity /
Minimum Division / Decimal Point Position
Set the weighing capacity, minimum division, and decimal point position. Be sure to perform these
setting first when connecting to a load cell (base unit). The indicator does not require setting each time,
if nothing is to be changed.
1. Refer to "7.1. Sensitivity Adjustment
the calibration mode. The indicator displays
2. Press the TARE
the weighing capacity, minimum division, and decimal
point position.
3. The indicator displays the currently set minimum
division and calibration unit.
(Display example:
The blinking digit indicates the minimum
division. Press the
The unit indicates the sensitivity adjustment unit. Press the
SAMPLE key to select either "kg" or "lb".
Press the TARE
minimum division and calibration unit, and proceed to
the next step.
4. After displaying
the currently set weighing capacity and decimal
point position. (Display example:
Set the weighing capacity and decimal point
position using the following keys:
MODE Shift the blinking digit to the right.
PRINT Increases the number (+1) at the blinking digit.
SAMPLE Shift the decimal point position.
Press the TARE
displayed weighing capacity and decimal point
position, and proceed to the next step.
Available setting range of the resolution is 100,000
or less. The resolution is the value that divides the
weighing capacity by the minimum division.
(Decimal point position is ignored.)
5. After displaying
and the setting is complete.
After setting the weighing capacity, minimum division,
and decimal point position, be sure to perform
"7.3. Sensitivity Adjustment Using a
Items", to enter
key to enter the setting mode of
kg )
-
PRINT key to select
key to store the currently set
, the indicator displays
key to store the currently
, the indicator displays
Weight".
.
, , or .
kg )
Press
(Select)
,
16
Press
Press
(Select)
Press
Press