Removing The Regulator Housing; Installing The Regulator Housing - MSA G1 Manual

Maintenance and Care

2.19 Removing the Regulator Housing

2.20 Installing the Regulator Housing

(1) Install all regulator components, including valve assembly, regulator buttons, and E-module
(See Installing the E-Module
(2) Install a new regulator seal ring and O-ring (See
tions).
NOTE: To remove / install the Intermediate Pressure (Regulator) Hose and Wiring from the pressure
reducer, please review the respective sections in the
Manual, 10164853.
US
22
(1) Remove the regulator. (See
Hose for instructions.)
(2) Remove all regulator components, including valve
assembly, regulator buttons, and E-module.
(See Removing the E-Module
(3) Inspect the regulator housing for wear or damage. If
damaged, discard the regulator housing.
NOTE: Do not reuse the regulator seal ring or O-ring at the
outlet on the new regulator housing.
for instructions).
Installing the Regulator Seal Ring
MSA G1 Carrier and Harness Assembly C.A.R.E.
G1
Removing the Regulator
for instructions.)
for instruc-