Operating The Projector; Auto Input Source Switching - Casio CX-E1 User Manual

Auto Input Source Switching

When the projector detects a signal from an input source (HDMI input or network input), it
automatically switches to that input source and starts projection. You do not need to perform any
projector key operation to switch the source.
Computer A
Computer B
Operation Example (See illustration above.)
Note
 The procedure below assumes that the projector, Computer A, and Computer B are all turned
on.
 The configuration for this procedure uses the C-Connection computer application to project
from the computers via the projector. For details about network projection, refer to the
"Network Function Guide".
1.
Use an HDMI cable to connect Computer B to the projector.
 The projector will detect HDMI input from Computer B and automatically switch its input
source to "HDMI". This starts HDMI projection of the Computer B screen.

Operating the Projector

Detects the last signal received
and switches to its source.
HDMI projection
(Input source: HDMI)
Network projection
(Input source: Network)
43
(Network model only)