Setup Menu Settings - Casio CX-E1 User Manual

To unlock the control panel
Perform one of the operations below.
 While there is no menu or dialog box displayed in the projection image, hold down the projector's
[] key. Release the key when the message "Control panel was unlocked." appears.
 To use the remote controller to unlock the control panel, perform the procedure under "To lock the
control panel" above. In step 4, press the [] key of the remote controller to select "Off" and then
press the [MENU] key.

Setup Menu Settings

 One or more letters (such as D) after the menu item name indicates an item that is available only
when one or more particular input source is selected. The letters indicate the input source(s) where
the menu item is available.
H: HDMI(PC), D: HDMI(DTV), N: Network (Network model only)
 A menu item that does not have any letter after it will be available regardless of the input source.
 Menu items with
 The initial default setting is indicated by an asterisk (*).
Use this menu item:
Image Adjustment 1 3
Brightness
Image Adjustment 1 3
Contrast
Image Adjustment 1 3
Color Mode
Image Adjustment 1 3
Color Balance
Image Adjustment 1 3
Restore Menu Defaults
Image Adjustment 2 3
Overscan (D)
Image Adjustment 2 3
Restore Menu Defaults (D)
Volume Adjustment 3
Volume
Volume Adjustment 3
Restore Menu Defaults
Screen Settings 3 Vertical
Keystone Correction
indicate information that applies to the network model only.
To do this:
Adjust projected image brightness.
Adjust projected image contrast.
Select one of the following projected image color modes: "Standard"*, "Graphics",
"Theater"*, "Natural".
Note
 Initial default setting: "Theater" when the input source is HDMI(DTV).
"Standard" when the input source is HDMI(PC) or Network.
Select one of the following color balance presets: "Warm", "Normal"*, "Cold".
Also can be used to separately adjust red, green, and blue.
Return all of the items in the "Image Adjustment 1" menu to their initial defaults for
the currently projecting image source.
Adjust the overscan amount for an input video signal within the range of 0%* to 5%.
The size of the border area displayed on the projection screen depends on the
setting value. A smaller value results in a wider border area as shown below.
Return all of the items in the "Image Adjustment 2" menu to their initial defaults for
the currently projecting image source.
Adjust the volume level.
For details, see "Adjusting the Volume Level" (page 49).
Return the Volume setting to its initial default for the currently projecting image
source.
Correct vertical keystoning of the projected image.
Display range at 5%
Display range at 0%
56