Handling Rechargeable Batteries (Please Recycle!); Soft Inner Case (Optional Yb-3) Precautions; Other Precautions - Casio CX-E1 User Manual

Handling rechargeable batteries (Please recycle!)

Be sure to recycle no longer needed batteries to help conserve precious resources. Do not
disassemble batteries. Recycle them "as-is". Contact your original dealer or authorized CASIO service
center for information about recycling.

Soft Inner Case (Optional YB-3) Precautions

 The soft inner case protects your projector and battery from scratching and dust. It does not protect
against damage due to dropping or strong external impact.
 Never try to load the projector into the case with its battery connected.
 The projector will be hot after use. Take care when handling it and inserting it into the soft inner
case.
 Liquids, rubbing against other objects, and other rough treatment may cause color fading and/or
discoloration.
 Prolonged close contact with clothing and other materials may cause color fading and/or color
transfer, chemical changes to the case surface, etc.
 Prolonged exposure to direct sunlight may cause color fading or discoloration.
 Storing in a well-ventilated location is recommended.
 Clean with a soft, dry cloth.

Other Precautions

This projector is made of precision components. Failure to observe the following precautions can
result in inability to correctly save data and malfunction.
 Never use or store the projector in the following locations. Doing so creates the
risk of malfunction of and damage to the projector.
 Locations subjected to electrostatic charge
 Locations subjected to temperature extremes
 Locations where there is extreme moisture
 Locations subjected to sudden temperature changes
 Locations where there is a lot of dust
 On a shaky, slanted, or otherwise unstable surface
 Locations where there is the danger of getting wet
 Locations where there are large amounts of oil smoke or other smoke
 Locations where there is the risk of salt damage
 Locations where corrosive gas (such as the sulfur gas at hot springs) is generated
 Never use the projector in an environment where large amounts of oil smoke are
present. In particular, ceiling or wall mounting the projector in an environment
where large amounts of oil smoke are present can result in the projector falling
from its mounting.
 Ensure that the remote control signal receiver is not exposed fluorescent light,
sunlight, or other strong light. Strong light can cause malfunction.
20