Changing Blade - Grizzly G0592 Owner's Manual

Changing Blade

All saw blades are danger-
ous and may cause per-
sonal injury. To reduce
the risk of being injured,
wear leather gloves when
handling and uncoiling saw
blades.
Item(s) Needed
Metal Brush or Shop Vacuum ........................... 1
Assistant ............................................................ 1
Leather Gloves (per person) .........................1 Pr.
Phillips Head Screwdriver #2 ............................ 1
Open-End Wrench 17mm .................................. 1
Replacement Blade ........................................... 1
Blades should be changed when they become
dull, damaged, or when cutting materials that
require a blade of a certain type or tooth count.
To change blade:
1.
DISCONNECT MACHINE FROM POWER!
2.
Raise headstock all the way, then use feed
control dial to keep it from lowering.
3.
Remove (2) blade covers by loosening (8)
knobs shown in Figure 30.
Blade Cover
(1 of 2)
x 8
Figure 30. Location of blade covers and knobs.
Model G0592 (Mfd. Since 01/23)
4. Move upper blade guide as far right as pos-
sible (see Adjusting Upper Blade Guide on
Page 36), then clean out all chips and shav-
ings with a brush and shop vacuum.
5. Loosen (2) knobs shown in Figure 31 to
remove front blade guard.
Qty
Blade Guard
Figure 31. Location of front blade guard and
6. Remove hex nut, flat washer, and spring
shown in Figure 32 to remove blade brush
assembly.
Blade Brush
Assembly
Figure 32. Example of removing blade brush
Front
knobs.
assembly.
x 2
-27-