Grizzly G0592 Owner's Manual page 60

— If square does not fit snugly against fixed
jaw and blade, disengage swivel stop,
then loosen jam nut shown in Figure 98.
Thread stop bolt in or out as necessary,
then engage swivel stop.
Stop Bolt
Jam Nut
Figure 98. Example of swivel stop bolt and jam
Setting 60° Stops
1. DISCONNECT MACHINE FROM POWER!
2. Raise headstock all the way.
3. Adjust headstock angle left or right until
base contacts left or right 60° stop bolt
(see Figure 99).
Left 60°
Stop
Figure 99. Example of 60° stop bolt contacting
base (left 60° stop shown).
4. Move vise to opposite side of track than
headstock was swiveled in Step 3.
-58-
nut.
5. Lower headstock all the way.
6. Place 60° square between outer fixed jaw
and blade, as shown in Figure 100. Square
should fit snugly against outer fixed jaw and
blade.
Outer
Fixed Jaw
60° Square
Blade
Figure 100. Example of using 60° square to
check 60° stop (left 60° stop check shown).
— If square fits snugly against outer fixed jaw
and blade, no adjustment is necessary.
— If square does not fit snugly against outer
fixed jaw and blade, loosen jam nut on 60°
stop (see Figure 101). Thread stop bolt in
or out as necessary until square fits snugly
against outer fixed jaw and blade while
base contacts stop bolt.
Figure 101. Location of 60° stop bolt jam nut
(left 60° stop shown).
Model G0592 (Mfd. Since 01/23)
Jam Nut