Grizzly G0592 Owner's Manual page 48

Adding Coolant
Items Needed
Safety Wear ....................................See Hazards
Coolant .............................................. As Needed
Clean Jug or Bucket .......................................... 1
Phillips Head Screwdriver #2 ............................ 1
To add coolant:
1. DISCONNECT MACHINE FROM POWER!
2.
Mix coolant according to cutting fluid manu-
facturer's specifications.
3.
Pour coolant through chip screen to fill reser-
voir with coolant until coolant sight gauge is
full (see Figures 78–79).
Chip
Screen
Figure 78. Location of chip screen.
Figure 79. Location of sight gauge.
-46-
Qty
Sight
Gauge
Changing Coolant
Items Needed
Safety Wear ....................................See Hazards
Coolant ................................................. 4 Gallons
Wrench or Socket 10mm ................................... 1
Phillips Head Screwdriver #2 ............................ 1
Disposable Shop Rags ...................... As Needed
Soap .................................................. As Needed
Clean Jug or Bucket .......................................... 1
To change coolant:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove (4) hex bolts and lock washers
shown in Figure 80 to lift coolant pump out
of base. Place it on its side in coolant pan.
Coolant
Pump
Figure 80. Location of coolant pump and
fasteners.
3. Remove (6) Phillips head screws and flat
washers shown in Figure 81 to remove stand
cover.
Figure 81. Location of stand cover and
fasteners.
Model G0592 (Mfd. Since 01/23)
Qty
x 4
Stand
Cover
x 6