Changing Blade - Grizzly T32005 Owner's Manual

Changing Blade

The blade is secured to the arbor with an
arbor screw and flange.
Tools Needed
Hex Wrench 2.5mm .................................. 1
To change blade:
1. DISCONNECT TOOL FROM POWER!
2. Pull blade guard straight up to remove
it (see Figure 5).
Blade
Guard
Figure 5. Removing blade guard.
CAUTION: Saw blades are sharp and
can cut even while tool is OFF. Wear
gloves to protect your hands while han-
dling and installing the blade.
-14
-
3. Hold blade in place and remove arbor
screw with 2.5mm hex wrench (see
Figure 6).
Qty
Figure 6. Holding blade in place to
4. Place new blade on arbor in correct
orientation (see Figure 7). If blade has
rotational arrow, align blade arrow with
arrow on saw.
Arbor
Flange
Figure 7. Blade on arbor with arbor screw
5. Hold blade in place and tighten arbor
screw with 2.5mm hex wrench.
6. Attach blade guard by pushing down
until it snaps in place.
Model T32005 (Mfd. Since 04/20)
Arbor
Screw
remove arbor screw.
and flange.
Arbor
Screw