Related Manuals for Kärcher HD 2.0/1000 Ed
Summary of Contents for Kärcher HD 2.0/1000 Ed
- Page 1 OPERATOR’S MANUAL MODEL # ORDER # HD 2.0/1000 Ed 1.106-124.0 HD 1.9/1300 Ed 1.106-125.0 HD 3.0/1000 Ed 1.106-126.0 HD 3.5/2000 Ea 1.106-127.0 HD 1.8/1300 Ed 1.106-128.0 KNA, Inc.4555 Airport Way Denver, CO 80239 9.801-810.0...
-
Page 3: Table Of Contents
CONTENTS Important Safety Information ..............4-5 Component Identification ................. 6 Assembly Instructions ................7 Operating Instructions................8 Detergent and General Operating Techniques ........9 Shut Down and Clean-Up ..............10 Storage ....................10 Troubleshooting ..................11 Preventive Maintenance ................ 12 Accessories and Parts list.............. -
Page 4: Important Safety Information
INTRODUCTION & IMPORTANT SAFETY INFORMATION DANGER: Improper connection of the equipment- Thank you for purchasing this Pressure Washer. grounding conductor can result in a risk of elec- We reserve the right to make changes at any time trocution. Check with a qualified electrician or without incurring any obligation. - Page 5 IMPORTANT SAFETY INFORMATION Inlet water must be clean fresh water and no WARNING: Grip cleaning wand WARNING hotter then 90°F. securely with both hands before starting. Failure to do this could 15. Manufacturer will not be liable for any changes result in injury from a whipping made to our standard machines or any components wand.
-
Page 6: Component Identification
COMPONENT IDENTIFICATION Pressure Pump Nozzle Protector Unloader Handle Water Supply (not included) On/Off Quick Switch Coupler Pump Detergent Safety Bucket (not Latch included) Garden Hose (not included) High Pressure GFCI Hose Spray Gun and Wand Pump — Develops high pressure. Pump Protector —... -
Page 7: Assembly Instructions
ASSEMBLY INSTRUCTIONS Spray Spray Pressure Gun/Wand Nozzle Safety Wand Latch Wand Coupler High Pressure Hose STEP 1: Attach the high pressure STEP 2: Attach wand to spray gun STEP 3: Pull spring-loaded collar hose to the spray gun using teflon using teflon tape on wand threads. -
Page 8: Operating Instructions
OPERATING INSTRUCTIONS Cold Water Source Garden Hose STEP 1: Connect garden hose to STEP 2: Trigger the spray gun to STEP 3: Connect to appropriate the cold water source and turn water eliminate trapped air then wait for power supply. Push reset button on completely. -
Page 9: Detergent And General Operating Techniques
DETERGENTS AND GENERAL OPERATING TECHNIQUES WARNING: Some detergents THERMAL PUMP PROTECTION WARNING may be harmful if inhaled or If you run the motor on your pressure washer for 1-2 ingested, causing severe nau- minutes without pressing the trigger on the spray gun, sea, fainting or poisoning. -
Page 10: Shut Down And Clean-Up
SHUTTING DOWN AND CLEAN-UP On/Off Switch STEP 1: Remove deter- STEP 2: Turn off machine STEP 3: Turn off water STEP 4: Press trigger to gent suction tube from by turning switch to “OFF” supply. release water pressure. container and insert into switch. -
Page 11: Troubleshooting
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION PUMP RUNNING Pump sucking air Check water supply and possibility of air seepage. NORMALLY BUT Check valves sticking Check and clean or replace if necessary. PRESSURE LOW ON Unloader valve seat faulty Check and replace if necessary. INSTALLATION Nozzle incorrectly sized Check and replace if necessary. -
Page 12: Preventive Maintenance
PREVENTATIVE MAINTENANCE PREVENTATIVE MAINTENANCE This pressure washer was produced with the best available materials and quality craftsmanship. However, you as the owner have certain responsibilities for the correct care of the equipment. Attention to regular pre- ventative maintenance procedures will assist in preserving the performance of your equipment. Contact your dealer for maintenance. -
Page 13: Accessories And Parts List
HOSE, 3/8" X 50' 1W 4000PSI SW X SO 8.750-247.0 Gun, M407 8.783-039.0 Wand 30" Zinc Plated, Handle & Coupler Quick Connect Nozzle Kit (3.5) (HD 2.0/1000 Ed) 8.712-338.0 ▲ Nozzle, SAQCMEG 1503.5, Yellow 8.712-339.0 ▲ Nozzle, SAQCMEG, 2503.5, Green 8.712-340.0... - Page 14 ACCESSORIES ASSEMBLY PARTS LIST ITEM PART NO. DESCRIPTION 9.802-166.0 Coupler, 3/8" Female, Brass 9.802-170.0 Coupler 3/8"PLUG, FEMALE, STEEL/ZINC 9.802-216.0 Injector, Chem, 0.083 6.388-216.0 Hose DN 5 5.731-652.0 Filter with weight 9.802-169.0 Coupler, 3/8" Socket, Male, Brass ▲ Not Shown • 9.801-810.0 • Operator's Manual • Rev. B...
- Page 15 OIL CHANGE RECORD Check pump oil and engine oil level before first use of your new pressure washer. Estimated Operating Estimated Operating Date Oil Changed Hours Since Last Date Oil Changed Hours Since Last Month/Day/Year Oil Change Month/Day/Year Oil Change •...
-
Page 16: Oil Change Record
KNA, Inc.4555 Airport Way Denver, CO 80239 Form #9.801-810.0 • Rev. B • Printed in U.S.A. or Mexico...
Need help?
Do you have a question about the HD 2.0/1000 Ed and is the answer not in the manual?
Questions and answers