Table of Contents
Advertisement
5.
Check V-belt tension by applying moderate
pressure between pulleys (see Figure 109).
— If deflection is approximately
ment is necessary.
— If deflection is not approximately
not correctly tensioned. Proceed to Step 6.
Deflection
Figure 109. V-belt deflection.
6.
Loosen (4) motor mounting hex nuts (see
Figure 110).
Figure 110. Location of motor mounting hex
nuts.
7.
Have assistant adjust motor position until
deflection is approximately
hex nuts from Step 6.
8.
Close and secure right blade cover and install
V-belt cover.
-56-
⁄
", no adjust-
1
4
⁄
", belt is
1
4
Bandsaw
Wheel
⁄
"
1
4
Motor
Wheel
x 4
⁄
", then tighten
1
4
Replacing V-Belt
Items Needed
Wrench or Socket 10mm ................................... 1
Protective Gloves..........................................1 Pr.
Safety Glasses .............................................1 Pr.
Open-End Wrench
⁄
" ....................................... 1
1
2
Replacement V-Belt (#P09602059) ................... 1
Another Person .................................................. 1
To replace V-belt:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove (2) hex bolts and flat washers shown
in Figure 111 to remove V-belt cover.
V-Belt
Cover
Figure 111. Location of V-belt cover and
fasteners.
3.
Perform Steps 2–4 of Removing Blade on
Page 36 to remove blade from wheels.
Saw blades are sharp and
may cause lacerations. To
reduce the risk of injury,
wear leather gloves when
handling saw blades.
Wear safety glasses when
handling blade.
Model G0960 (Mfd. Since 09/22)
Qty
x 2
Advertisement
Table of Contents
